Cookie Consent by Free Privacy Policy Generator

Demontage von Sturmey-Archer Naben: Unterschied zwischen den Versionen

(in arbeit!)
Zeile 4: Zeile 4:


When gear and brake controls and electrical wires (if any) have been disconnected and the wheel removed from the cycle frame , dismantling of the hub begins with the removal of the left-hand locknut, the washers (if any) and the left-hand cone. A note should always be made of their order and number so that they may be put back correctly when the hub is re-assembled. In particular, different numbers of spacer washers may be fitted, depending on the spacing and chainline.
When gear and brake controls and electrical wires (if any) have been disconnected and the wheel removed from the cycle frame , dismantling of the hub begins with the removal of the left-hand locknut, the washers (if any) and the left-hand cone. A note should always be made of their order and number so that they may be put back correctly when the hub is re-assembled. In particular, different numbers of spacer washers may be fitted, depending on the spacing and chainline.
Left Axle Nut
<gallery>
Left Axle Nut HMN128
Datei:hmn128.jpg|Mutter linke Achsenseite HMN128
HMN128 Axle Washer
Datei:Sturmey-HMW155.jpg|Unterlegscheibe Achse HMW155 oder HMW94
Axle Washer
Datei:Hmn132.jpg|Kontermutter HMW132
HMW155 or HMW494 Locknut
Datei:hmw129.jpg|Unterlegscheibe HMW129
Locknut hmn132
Datei:hsa101.jpg|Konus HSA101
HMN132 Spacer
</gallery>
Spacer HMW129
 
HMW129 Cone
Cone HSA101
HSA101
The parts shown above are common to most models that do not incorporate a brake.
The parts shown above are common to most models that do not incorporate a brake.
===Models With Built-in Brake===
===Models With Built-in Brake===
Zeile 21: Zeile 18:
===Models With Dynohub Generator===
===Models With Dynohub Generator===
Similarly, the generator must first be removed from hubs incorporating a Dynohub lighting unit. The procedure is explained in detail in the appropriate chapters of this section of the catalogue
Similarly, the generator must first be removed from hubs incorporating a Dynohub lighting unit. The procedure is explained in detail in the appropriate chapters of this section of the catalogue


==Unscrew the right-hand ball ring and internal assembly==
==Unscrew the right-hand ball ring and internal assembly==
15.321

Bearbeitungen