Die Sturmey-Archer ASC Fixed Gear Drei-Gang-Nabe/Wartung der Sturmey-Archer ASC Fixed Gear Drei-Gang-Nabe: Unterschied zwischen den Versionen

Proceed as follows:

#Prepare the following preliminary sub-assemblies:

#*        Fit the ball cage into the left-hand ball cup, with the ring of the ball-retainer facing outwards and the recess in the dust cap also facing outwards. If a new ball-retainer is being fitted, the dust cap also should be new.

#*        Fit the ball cage into the driver, with the ring of the ball- retainer facing outwards and the recess in the dust cap also facing outwards. If a new ball-retainer is being fitted the dust cap also should be new. If the sprocket has been removed see No. 27 below.

#    If the sprocket has been removed from the driver, fit the outer dust cap over the driver before replacing the sprocket, and see that the dust cap is properly centered on the flange of the driver. Replace the sprocket and the spacing washers in the arrangement noted when dismantling, and add the circlip.

#    Replace the wheel in the cycle frame and adjust the gear as described in The Fitting and Adjustment of Sturmey-Archer Hubs.

==Quelle==