Bürokraten, editor, Administratoren
15.322
Bearbeitungen
Wartung von Steuersätzen: Unterschied zwischen den Versionen
K
→Replacement/Installation: Überschriften
K (→Replacement:: Überschrift) |
K (→Replacement/Installation: Überschriften) |
||
| Zeile 153: | Zeile 153: | ||
For a threadless system, you need to secure the fork before turning the bike right-side up. I sometimes use an old toe strap for this, tying the fork crown to the down tube of the frame. | For a threadless system, you need to secure the fork before turning the bike right-side up. I sometimes use an old toe strap for this, tying the fork crown to the down tube of the frame. | ||
== | ==Ausbauen und Einbauen== | ||
Removing and re-installing the headset bearing races is not necessary for a normal overhaul, only when you are replacing the headset or installing a new fork. | Removing and re-installing the headset bearing races is not necessary for a normal overhaul, only when you are replacing the headset or installing a new fork. | ||
| Zeile 159: | Zeile 159: | ||
The following assumes you're working with an all-steel headset: | The following assumes you're working with an all-steel headset: | ||
=== | ===Ausbau=== | ||
The races can usually be removed with a hammer and an old flat-blade screwdriver that you don't care about. | The races can usually be removed with a hammer and an old flat-blade screwdriver that you don't care about. | ||
| Zeile 171: | Zeile 171: | ||
Some races and some fork crowns give very little to grab onto. There are special shop tools to work around this problem, so you might want to just bring the fork into your local shop and have it remove the race. | Some races and some fork crowns give very little to grab onto. There are special shop tools to work around this problem, so you might want to just bring the fork into your local shop and have it remove the race. | ||
=== | ===Einbau=== | ||
The press-fit races need to be seated firmly. | The press-fit races need to be seated firmly. | ||