Kettenpflege: Unterschied zwischen den Versionen

A worn chain on a new sprocket. Due to the pitch mismatch, the load is only carried by the teeth/rollers on our right, the chain hangs slack on our left. The new sprocket will wear rapidly to match the pitch of the worn-out chain. [In this case, Sheldon is probably correct, though the chain also could "ride high" all the way around. Some sprockets in a cluster get more use than others, and so sometimes a chain will be running on a (nearly) new sprocket even on an old cluster -- John Allen]

The standard way to measure chain wear is with a ruler or steel tape measure. This can be done without removing the chain from the bicycle. The normal technique is to measure a one-foot length, placing an inch mark of the ruler at the side of one rivet, then looking at the corresponding rivet 12 complete links away. On a new, unworn chain, this rivet will also line up exactly with an inch mark. With a worn chain, the rivet will be past the inch mark. [For accurate measurement, the chain should be held under some tension -- either on the bicycle, or hanging. Also, use a metal ruler or tape measure. Wood, plastic and cloth all can expand or shrink.-- John Allen]

There are also special tools made to measure chain wear; these are a bit more convenient, though by no means necessary, and most -- except for the Shimano TL-CN40 and TL-CN41 -- are inaccurate because they allow roller play to confound the measurement of rivet-pin wear.

==Kettenlänge==

This issue is discussed in my Article on Derailer Adjustment