Sturmey-Archer Teile und Namen: Unterschied zwischen den Versionen

This shows the sort of things you will find on the left-hand side of the hub.

From the left of the diagram : left-hand axle nut, axle locking washer, cone locknut, Axle cone with dustcap, outer dust cap, ball cage with balls, left-hand ball cup.

And this shows what you will find on the right-hand side:

From the left : outer dust cap, sprocket dust cap, sprocket spacing washer, sprocket, circlip, axle cone and dust cap, right-hand cone locking washer, cone locknut, axle locking washer, right-hand axle nut.

This is the hub shell and right-hand ball ring:

And here are some of the weeny vital bits you'll find inside:

Clutch sleeve, collar for compensator spring (very weeny!), compensator spring, sliding clutch, axle key, thrust ring, thrust washer, clutch spring, clutch spring cap.

And some more vital bits from right in the middle - you may never get to dismantle these :

Locknut, locking washer, dog ring, low gear key, pinion sleeve, secondary sun pinion, primary sun pinion. The dual sun-pinions are not generally used on three-speed models.

Gear ring and driver (These are common to most models.):

Planet cage:

On the left is the planet cage with all its bits still in. You should be able to remove various bits from here : pawls, pawl pins and hair-like springs that get lost, and are somewhat difficult to put back in. And a selection of planet pinions and pins.

indicator rods - these may be in 2 halves like this one, but most three-speed models use a single piece indicator rod that threads into the axle key.

And lastly, the bare axle with low gear spring - these do vary a lot in appearance, but I'm sure you'll know this bit when you see it! :

==Siehe auch==