Bürokraten, editor, Administratoren
15.340
Bearbeitungen
Über Konusschlüssel: Unterschied zwischen den Versionen
Aus WikiPedalia
→Spiel reduzieren: ergänzung
(→Misshandlung vermeiden: übersetzt) |
(→Spiel reduzieren: ergänzung) |
||
| Zeile 56: | Zeile 56: | ||
At this point, there should be no noticeable play in the axle. if you cannot eliminate almost all of the play from the axle without causing the bearings to bind, the hub needs to be cleaned and repacked, possibly with some new parts. | At this point, there should be no noticeable play in the axle. if you cannot eliminate almost all of the play from the axle without causing the bearings to bind, the hub needs to be cleaned and repacked, possibly with some new parts. | ||
{{Ergänzung|Ergänzung durch [[John Allen]]| | |||
Some hubs with sealed cartridge bearings have double locknuts on each end. The axle generally has a flange inboard each bearing. The bearing's inner race is clamped between this flange at the inside and the inner locknut at the outside. The cartridges use radial-contact bearings: that is, the bearing balls ride in the bottom of rounded grooves in the inner and outer raceways, rather than on angled surfaces as in cup and cone bearings. | Some hubs with sealed cartridge bearings have double locknuts on each end. The axle generally has a flange inboard each bearing. The bearing's inner race is clamped between this flange at the inside and the inner locknut at the outside. The cartridges use radial-contact bearings: that is, the bearing balls ride in the bottom of rounded grooves in the inner and outer raceways, rather than on angled surfaces as in cup and cone bearings. | ||
| Zeile 61: | Zeile 62: | ||
Despite the locknuts, this kind of hub is non-adjustable. It should turn freely, and if installed in a wheel, there should be a very slight amount of play at the rim. If it binds, that is probably because the bearing balls are riding on the side of the raceway. This can occur if the cartridge is not properly seated due to dirt or burrs, or if the axle is not exactly right for the hub. | Despite the locknuts, this kind of hub is non-adjustable. It should turn freely, and if installed in a wheel, there should be a very slight amount of play at the rim. If it binds, that is probably because the bearing balls are riding on the side of the raceway. This can occur if the cartridge is not properly seated due to dirt or burrs, or if the axle is not exactly right for the hub. | ||
}} | |||
==Die Achse komprimieren== | ==Die Achse komprimieren== | ||
