Klassische Schraubkranzfreiläufe: Unterschied zwischen den Versionen

Klassische Schraubkranzfreiläufe (Quelltext anzeigen)

1.070 Bytes hinzugefügt , 2. Oktober 2019

15.340

Bearbeitungen

@@ Zeile 112: / Zeile 112: @@
 Dies sollte man ungefähr mindestens einmal im Jahr oder  sobald sich das Geräusch der Sperrklinken laut und knirschend anhört wiederholen.
+If the right side of the freewheel body is dirty, remove the wheel, then the freewheel. The back side of the freewheel may be clean. In that case, you may drip oil into the crack on the back side while spinning the inner body.
+If neither side is clean, you have three choices:
+*    Replace the freewheel.
+*    Rebuild the freewheel, so you can clean all the internal parts thoroughly. See our article on freewheel rebuilding.
+*    First scrape off as much grit and grime as you can, then flush the old lubricant out of the freewheel before relubricating it, To do this, you will need a parts cleaning bath, preferably with a sprayer. Loosening the outer ring by a couple of turns can create a larger gap into which to spray the cleaning solution.
+Phil Wood & Co. used to make a grease injector for freewheels. The freewheel would screw onto this the way it screws onto a wheel. You could pump enough grease into a freewheel to push all the dirt out. However, only very light grease -- or oil -- should be used, because thick grease prevents the pawls from engaging.
 == Ersetzen von Ritzeln und Restaurieren==