Lenkerband wickeln: Unterschied zwischen den Versionen

Strips to hide cbrake lever clamp

The photo below shows the "shingle" effect (green arrow) which results from starting taping from outside to inside on the underside at the end of the handlebar, and the exposed Sachs trigger tabs, bolt and nut (red arrow). The tape should usually extend far enough toward the center of the handlebar that your hand has room to sit entirely on the tape. A carbon-fiber handlebar may have a longer bulge at the center, so the tape toes not go as close to the center. As with the beginning, cut the end diagonally, but the end section is a full-width diagonal cut, about 6 inches long tapering to a sharp point. The adhesive finishing strip will then fit without wrinkling, since the tape thickness is constant right up to the cut end. The Bontrager finishing strip shown is elastic and should be stretched so it secures the tape well. Pull it in the same direction as the tape was wrapped. Cloth tape, in particular, can be finished with a wrap of twine, as described on the page from Rivendell Bicycle Works linked at the end of this article.