Bürokraten, editor, Administratoren
15.340
Bearbeitungen
Die Sturmey-Archer Sprinter Fünf-Gang-Nabe: Unterschied zwischen den Versionen
Aus WikiPedalia
Die Sturmey-Archer Sprinter Fünf-Gang-Nabe (Quelltext anzeigen)
Version vom 3. August 2021, 06:33 Uhr
, 3. August 2021→Demontage: Bilder hinzugefügt
(→Wartung: typos) |
(→Demontage: Bilder hinzugefügt) |
||
| Zeile 96: | Zeile 96: | ||
===Demontage=== | ===Demontage=== | ||
[[Datei:sprint9.png|right|Innerer Aufbau einer Sprinter 5 Nabe]] | |||
* Remove the indicator rod, indicator protectors or gear selector guide (if fitted), axle nuts and spacing washers from both ends of the axle. | * Remove the indicator rod, indicator protectors or gear selector guide (if fitted), axle nuts and spacing washers from both ends of the axle. | ||
* Use a screwdriver to release the sprocket circlip from the driver, then remove the spacing washer, sprocket, and outer dustcap (Note the order of these parts). | * Use a screwdriver to release the sprocket circlip from the driver, then remove the spacing washer, sprocket, and outer dustcap (Note the order of these parts). | ||
* | * Unscrew left hand cone locknut (Remove cone adjuster and brake assembly ELITE). Note position of any washers fitted. | ||
* Unscrew the right hand ball ring with a 'C' spanner or hammer and suitable punch, and unscrew the ball ring to release the internal assembly from the hub shell (See diagram 7). | * Unscrew the right hand ball ring with a 'C' spanner or hammer and suitable punch, and unscrew the ball ring to release the internal assembly from the hub shell (See diagram 7). | ||
* Clamp the left hand end of the axle in a vise and remove the right hand cone locknut, lockwasher, cone, clutch spring cap and clutch spring (See diagram 8). | * Clamp the left hand end of the axle in a vise and remove the right hand cone locknut, lockwasher, cone, clutch spring cap and clutch spring (See diagram 8). | ||
| Zeile 114: | Zeile 114: | ||
** Check free movement of driver actuator and pawl action by inserting clutch and turn (See diagram 12). Note: it is recommended that this assembly is not dismantled but if necessary replace with a new assembly. | ** Check free movement of driver actuator and pawl action by inserting clutch and turn (See diagram 12). Note: it is recommended that this assembly is not dismantled but if necessary replace with a new assembly. | ||
** Gear selector key - Check threads for wear and free movement in axle slot. | ** Gear selector key - Check threads for wear and free movement in axle slot. | ||
** | ** Clutch - squareness of drive corners. | ||
[[Datei:sprint10.png|Entfernen des Sprengrings bei einer Sprinter 5 Nabe]][[Datei:sprint11.png|Reihenfolge der Sonnenräder bei einer Sprinter 5 Nabe]][[Datei:sprint12.png|Manueller Funktionstest von Mitnehmer und Sperrklinkenfunktion durch Drehen bei einer Sprinter 5 Nabe]] | |||
===Zusammenbau=== | ===Zusammenbau=== | ||
