Die Sturmey-Archer Sprinter Fünf-Gang-Nabe: Unterschied zwischen den Versionen

===Zusammenbau===

*    Clamp the drilled end of axle horizontally in vise with slot uppermost (See diagram 13).

*    Using a small screwdriver compress indicator spring towards vise and insert gear selector key assembly.

**        Fit planet cage spring and planet cage ensuring pawl end uppermost.

**        Take new circlip and locate it in the circlip groove, ensuring that circlip sharp corners are uppermost. Note: TAKE CARE NOT TO OVERSTRESS CIRCLIP

*    Clutch Installation

**      Remove axle from vice. Reclamp left hand end of the axle in vice (See diagram 14)

**        Fit clutch ensuring it meshes with the top of the pinion pins.

**        Fit washer into clutch (See diagram 9).

*    Gear ring Pawl, Ball Ring, Driver Assembly

**        Take gear ring and fit the pawls pawl pins and springs if required as indicated (See diagram 16).

**        Rotate the actuator anti-clockwise to compress pawls (See diagram 12)

**        With actuator in this position fit driver assembly, rotating ant-clockwise to ensure that driver engages with the clutch splines.

*    Right-hand Cone Adjustment

**        Slide on the clutch spring and then the cap (with its flat face uppermost) over the axle and locate on the spring.